Contact Us
TEL: +86-511-85722368
Mob: +86-15805290338
E-mail: tyb@cn-meihua.com
Address: Pan Zonglu, Ding MAO Development Zone, Zhenjiang City, Jiangsu Province
Solar Cell Automatic Welding Seaming Production Line

Solar Cell Automatic Welding Seaming Production Line

The automatic welding line production line is mainly used for the welding and closing of the amorphous silicon thin film solar cells. The main production processes: drainage strip welding, transmission and control, test bench with bus bar insulation cover tape, welding, cutting, EVA film EVA...

1.jpg The automatic welding line production line is mainly used for the welding and closing of the amorphous silicon thin film solar cells. The main production processes: drainage strip welding, transmission and control, test bench with bus bar insulation cover tape, welding, cutting, EVA film EVA film, back cover glass, which is welded on the bus bar and the cover EVA film can access equipment or affixed to butyl rubber seal around rubber equipment.


technical parameters

1, back plate size: length 1000 to 2600mm width 400 ~ 2200mm thickness 3 ~ 6mm

2, the size of back plate glass: length from 1000 to 2600mm, 400 ~ 2200mm thickness 3 ~ 6mm

3, the production line speed: 60s

4,production lines, the overall size is less than or equal to L 14m * W 6m * H 2m; transmission height: 1m

5, compressed air equipment more than 0.6MPa vacuum pressure is less than 70KPa, the power supply voltage of single-phase AC220V

6. The principle of substrate positioning for the production line: the upper left corner of the substrate transmission


Hot Tags: solar cell automatic welding seaming production line, China, manufacturers, suppliers, factory, buy, made in China
Inquiry